smok rpm160 kit-user review

RPM160 pod  system Smok Vape Pen is a mod kit that has a compact structure, ergonomic comfort and innovative chip design.

We share with user guides.

Safety instructions
1) Charge inside the battery only;

2) Do not use a power source that does not have a legal license local manufacturing.

Preparation for use
1) Please make sure that the battery you are using matches Uwell Amulet Vape Pod   theBATTERY WARNING CARD

2) Before vaping, please make sure that the platform is sufficiently illed e-juice.

Battery installation
1) Drag and open the battery cover as the image;

2) Place two 18650 cells in the device of the correctdirections;

3) Close the battery cover

IJOY Mystique Mesh Tank 3ml 0.15ohm 3PCs

1. Power:

7 Easy Ways to Make Good Use of Vape Bands - Vaping360

When the camera is turned fast release time 5 fire button IN2 seconds to turn on. The display shows the product logo “RPM160” and version information;

2. Vaping:

While the device is on, press the fire button to vape (it will be forced to stopworking when vaping time is more than 8 seconds, release and pressagain vape again);

Short press the Fire button 3 times to lock or unlock the vaping function.

3. screen unlocked status:

1) Press the UP or DOWN buttons to choose your desired power;

2) Press the UP and DOWN simultaneously to lock or unlock the thewattage adjustment function;

3) Press the button and fire BAS simuitaneously to clear thenumber puffs;

4. Charging:

When the USB cable is inserted, the charging interface appears and displays the percentage of battery two batteries and the time estimated load Steam Crave Aromamizer Plus.

5.Power Off:

While the device is on, press fast IN2 second fire time for the off button.

RPM160 Pod

How to fill with e-liquid

Remove the rubber plug on the slot;
Add the e liquid through the slot;
Press the rear rubber stopper gently and firmly.

Appendix 1 Key Function
key function
Key Fire click Fast 5 times 2S Power On / Off
click 3 times fast – lock or unlock vape vape FunctionHold On-
Hold vape
Up Click to increase power
Click down to reduce power
Up + Down lock or unlock the power control function
Fire Down key + Delete number puff
Appendix 2 screen messages
prompts Details
LOW BATTERY The battery voltage is less than 3.2Vt0.1V or the battery voltage is less than 2.5Vt0.1V during vaping.
NO ATOMIZER pods installed NO
OHMS TOO SMALL The resistance is less than 0.10t5%
TOO HIGH OHM resistance ls more than25015%
BLAST SHORT Short circuit has been detected.
The temperature PCBATOO HOT PCBA is too high and high temperature protection starts VAPJOY DIY Rebuild Kit .
TIME When the time is vaping over 8 seconds
The functions WATTS BLOCKED locked power control (you can not change the power by pressing the UP / DOWN).
The function POWER BLOCK vaping is locked (you can not fire when locked).
This is the end of the post, welcome to leave your thoughts on the section for feedback!

Click here!

Leave a Reply

Your email address will not be published. Required fields are marked *